BTC core
Taking t2t-30t as an example, the calculation force of t2t-30t is 30t, and the power consumption is 2200W, that is, 2.2kW. The power consumption of a single miner in 24-hour operation is 2.2kW * 24 = 52.8kwh, and the electricity charge is once calculated as 0.56rmb, the daily power consumption cost of a single miner is 52.8kw * 0.56 = 29.57rmb
to "mine" with bitcoin mining machine, if the graphics card is fully loaded for a long time, the power consumption will be quite high, and the electricity bill will be higher and higher. There are many professional mines at home and abroad in areas with extremely low electricity charges, such as hydropower stations, while more users can only mine at home or in ordinary mines, so the electricity charges are not cheap. Even some people in a residential area in Yunnan carried out crazy mining, which led to a large area trip of the residential area, and the transformer was burned
extended data
mining principle of bitcoin mining machine:
bitcoin mining and node software mainly initiates zero knowledge proof and verification transactions through point-to-point network, digital signature and interactive proof system. Each network node carries out broadcast transactions to the network. After these broadcast transactions are verified by miners (computers on the network), miners can use their own work proof results to express confirmation. The confirmed transactions will be packaged into data blocks, and the data blocks will form a continuous data block chain
every node of bitcoin will collect all the unconfirmed transactions and gather them into a data block. The miner node will add a random adjustment number and calculate the sha256 hash value of the previous data block. The mining node keeps trying again and again until the random adjustment number it finds makes the hash value lower than a specific target
There is a flat head screw at the bottom of carburetor, which can be unscrewed
carburetor is a key part of engine, small changes may affect vehicle performance. Therefore, in the process of carburetor disassembly, appropriate tools should be used, and the force should be moderate, so as to prevent the deformation of parts. The disassembled parts should be placed in order in order to prevent missing or wrong assembly
in the process of cleaning the carburetor, if more deposits are found in the float chamber of the carburetor, it is often caused by the failure of the gasoline filter. At this time, the gasoline filter should be checked. If the failure is confirmed, the gasoline filter should be cleaned or replaced
extended information:
precautions:
1. Carburetor is a key part of engine, small changes may affect the vehicle performance. Therefore, in the process of carburetor disassembly, appropriate tools should be used, and the force should be moderate, so as to prevent parts from deformation. The disassembled parts should be placed in order in order to prevent missing or wrong assembly
2. The carburetor should be cleaned in a clean place, the outer surface of the carburetor should be cleaned, and the internal parts can be cleaned with special cleaning agent for carburetor or instrial gasoline. In addition to impurities, pay attention to clean the gasoline gum on the surface of parts
3. Clean the cleaned parts with compressed air, and do not wipe them with cloth or paper that may cause burr to prevent re pollution. It is forbidden to poke the blocked small hole with steel wire and other hard objects to prevent the change of carburetor performance caused by changing the aperture. Gasoline or compressed air should be used to wash out