Yingtai b250btc wiring

1. Yingtai tb250-btc D + motherboard is a mining professional board. Why separate power supply for each of the pcies? This is because a single interface power supply is not enough. With so many independent graphics cards, it is necessary to plug them separately. This is designed for the stable use of multiple graphics cards,

2. Yingtai tb250-btc D + motherboard is a mining motherboard. The miner needs a special power supply. The output ports all use 6pin interface, all of which are 12V output. The 5V and 3.3V power supply interfaces in 24pin are canceled. The motherboard belongs to a professional application board, so it is not suitable for ordinary PC host power supply, so it needs to use a special 6pin 12V full interface power supply. Such as: quanhan fsp1600w rated power mining special power supply.

3. You don't talk about the model of the motherboard and the cable to be connected. It's the chassis connecting the motherboard switch restart line. No, this is relatively simple, but the problem is that there are several connection methods. I'll send you two kinds of wiring diagrams for reference,

4. Special power supply

such as quanhan fsp1600w rated power mining special power supply
the output ports of special power supply for mining machine all adopt 6pin interface, all of which are 12V output, and 5V and 3.3V power supply input in 24pin are cancelled

5. The lower right corner of the picture seems to be the interface of the front panel of the chassis, because the picture is too fuzzy
it is suggested to take a clear picture and send it to confirm.

6. If multiple independent graphics cards are installed on Yingtai tb250-btc D + mining motherboard, any one of the graphics cards can be connected to the display to start normally.

7. Insert the corresponding pin according to the prompt, the green SPK is the speaker, the orange hled is the hdled, and RST is reset
power is the power supply

10. If the upper four pins and the lower five pins are used, all motherboards are connected in the same way
powerled

power
SW (on key)
hddled

Reset
SW (restart key)