Decoupling tank and mixing Center

1. Everything has its advantages and disadvantages. In theory, water flow can be increased by adding coupling tank. But. If the water flow is large, the boiler will have to burn at a higher temperature theoretically. Or it won't be hot. So if there are conditions not to add, try not to add. There's no way. The later operation cost is certainly high. In particular, it is not recommended to use it when the usage is small.. This temperature is very difficult to control.

2. Is there a mistake? Take a picture. In addition, is the water temperature set low

3. Water mixing tank is a kind of device used for mixing cold and hot water. It is equipped with drain valve and automatic exhaust valve. It is a high-end floor heating water mixing system, which is widely used in wall mounted boiler system
the mixing tank can make the primary cycle and secondary cycle run independently. The flow rate of each circulating system only depends on the technical parameters of its own pumps, so as to avoid the interference caused by the series connection of pumps
the all copper water mixing tank is an integrated device of water mixing tank and water pump, which is easy to install without debugging
it can save more than 25% gas.

4. Zhou Gong, only the Weineng can be called decoupling tank, the others are called mixing water

5. Decoupling tank, commonly known as water mixing tank, refers to the use of water system heating, e to the existence of hydraulic coupling between the circuits, when a branch or user's flow changes, the flow of other branches or users and the boiler's flow will be affected, so that the water balance of each cycle circuit is broken. The decoupling treatment is carried out by using a device which creates an area with almost zero pressure loss to make the pumps realize their own circulation, mutual non-interference and heat transfer without loss. The device is called decoupling tank. Function and function of decoupling tank: the user can adjust the temperature of each room by using electric temperature control valve or manual temperature control valve, which causes the change of flow and pressure in the heating system. The function of decoupling tank can balance the pressure in the wall hanging furnace system and the heating system, and has no effect on the flow of the wall hanging furnace system; On the other hand, for the closed small boiler heating system, the application of decoupling tank can avoid the energy waste caused by the frequent start-up of the boiler and protect the boiler; Second, the installation of decoupling tank in the floor heating system can realize the technical advantages of large flow and small temperature difference of the floor heating system, and it is the first choice for wall mounted furnace and prefabricated thin floor heating system.

6.

Lotus pot is to eliminate the coupling effect, not to mix water to cool down, no need to set the temperature. If there is no water mixing center, the wall mounted furnace doesn't need to turn on such a high temperature. The water supply temperature of floor heating is 40-50 degrees. In the case of meeting your indoor temperature, the lower the water temperature set by the wall mounted furnace, the more energy saving

if there is a water mixing center, the wall mounted furnace can be set at 60 ℃, and then let the water mixing center cool down and enter the floor heating pipeline. Similarly, the lower the water temperature set in the mixing center is, the better

the figure below shows the floor heating water distributor with mixing center

9. One counterfeiter took a 15 yuan note to buy something and got back 2 pieces of 7.5 yuan note

10. Online rating coin box is only a few yuan