Effective force conversion

2. Lightcoin calculator calculated for reference only, not necessarily real income, recommend several mining graphics card to you, hd7990 R9 290x gold slave miner data card R9 280x

3. The computing power of CPU is related to the number of CPU cores, the frequency of core and the ability of single clock cycle of core
the ability of double precision floating-point computing is commonly used to measure the scientific computing ability of CPU, that is, the ability to process 64 bit floating-point data

the processor supporting avx2 can perform 16 floating-point operations in one core and one clock cycle, Also known as 16flops
CPU power = number of cores x frequency of cores x 16flops
processors supporting avx512 can perform 32 floating-point operations in one core and one clock cycle, also known as 32flops
CPU power = number of cores x frequency of cores x 32flops

4. 1bar=0.1Mpa
1Mpa=1000000pa
1[UNK]标准压[UNK]=1.00336×0.098MPa=0.10108MPa√0.1Mpa.

5. Tragically, it should be less than 0.01 yuan

6. I've been doing it for months. It's not like that at all

7. Because it is a standard cuboid, the center of gravity is in the center of the object, so:
F = 22000 ÷ 2 = 11000 (KGF)

8. Stale, make bad

9. Hello friend, check the hydraulic system for leakage. If there is, the system pressure will not rise, and the workpiece will not be clamped tightly. The leakage is mainly caused by the wear of sealing elements. The solution is to find out the worn sealing elements and replace them with new ones. In addition, the hydraulic oil damp or more impurities will also lead to a drop in system pressure. The treatment method is to filter and dry or replace with new hydraulic oil that meets the requirements. Measure the hydraulic pressure, if it changes, adjust the pressure, because the pressure is the only guarantee to ensure the clamping force. The hydraulic system of metal belt cutting machine generally uses gear pump as the system pressure output. If it is used for a long time, the system pressure will not rise when the unloading in gear pump is large, and the workpiece will not be clamped tightly. In addition to what you have mentioned above, there is another important factor. The spring of the relief valve may become loose after a long time of use. Please check whether the oil seal of the oil cylinder is damaged. Then check the pressure setting and wear of the relief valve, the internal leakage of the directional valve, the internal leakage of the oil pump and the internal leakage of the hydraulic control check valve. I'm glad to serve you. I hope my answer will help you. Thank you for your support and encouragement.