1660s Hynix super frequency computing power or 24
Publish: 2021-04-13 19:28:50
1. Memory system is not good, do not super high, it is best to set in BISO. Sometimes, adjust the memory voltage a little bit (but need the support of the motherboard)
2. Weak, good quality particles, 3000 frequency easy, 3200 a few can, 3600 basically do not go (do not rule out good physique, manual super up)
sharp dragon platform
Samsung b-die is the best, followed by Hynix, the worst MgO
sharp dragon platform
Samsung b-die is the best, followed by Hynix, the worst MgO
3. No need to verify, Hynix's memory is basically not copied, unless there is a problem when it comes out.
4. Step 1 start the computer and press del to enter the main interface of BIOS Setup
Step 2 select "frequency / voltage control" in the main menu. Press enter to enter
in step 3, you can see "host CPU / DIMM / PCI clock" and "CPU clock ratio". The former enables you to set the external frequency of CPU, while the latter enables you to double the frequency of CPU. If you want to change the external frequency, move the cursor to the "host CPU / DIMM / PCI clock" item, and press page up or page down to change it
in step 4, its value can be adjusted from 100MHz to 133MHz, which improves the performance of CPU by increasing the external frequency of CPU
in step 5, for the CPU without locking frequency doubling, the method of increasing frequency doubling can be used for overclocking. In the "Pu clock ratio" option, selecting the appropriate frequency multiplication can greatly improve the CPU performance (now the frequency multiplication of general CPU is locked)
building main attention
overclocking to slowly, a 3 -- 5MHz. Otherwise it will not start
if the boot screen is black, it means that the overclocking is too high. Use the jumper to rece the frequency
if you can adjust the voltage, you can appropriately increase the working voltage of CPU and memory by 0.1V
Step 2 select "frequency / voltage control" in the main menu. Press enter to enter
in step 3, you can see "host CPU / DIMM / PCI clock" and "CPU clock ratio". The former enables you to set the external frequency of CPU, while the latter enables you to double the frequency of CPU. If you want to change the external frequency, move the cursor to the "host CPU / DIMM / PCI clock" item, and press page up or page down to change it
in step 4, its value can be adjusted from 100MHz to 133MHz, which improves the performance of CPU by increasing the external frequency of CPU
in step 5, for the CPU without locking frequency doubling, the method of increasing frequency doubling can be used for overclocking. In the "Pu clock ratio" option, selecting the appropriate frequency multiplication can greatly improve the CPU performance (now the frequency multiplication of general CPU is locked)
building main attention
overclocking to slowly, a 3 -- 5MHz. Otherwise it will not start
if the boot screen is black, it means that the overclocking is too high. Use the jumper to rece the frequency
if you can adjust the voltage, you can appropriately increase the working voltage of CPU and memory by 0.1V
5. Isn't there software? Slowly surpass. It's too much. Just restart it
Hot content