CAD to the center point between two lines

1. Take the middle line between parallel lines
make a line segment perpendicular to them, and then use auto capture to draw a middle line you want; If you know the distance, half the offset is also...

2. Drop down menu: Drawing - point - fixed number equal division - input line segment number: 2
drop down menu: format - point style

3. I don't even know what line you're talking about? But press F3 to turn on the object snap. Right click to set the snap point. You can tick the center to capture the center of each line
supplement: the original two-day parallel lines are line B and line C. After setting the center snap, press F8 to snap to the midpoint of the first parallel line B, draw a straight line from the midpoint of line B to the midpoint of the second parallel line C, and this line is used as line D. Is the line drawn left or right at the midpoint of line d the line you want?

4. When placing: right click and select & quot; The midpoint between two points & quot; Or input m2p directly, take any point on both lines, OK

5. As shown in the figure, there are two cases: the first is to make any circle for two lines, connecting the intersection point of two lines to the center of the circle. If two lines are not allowed to extend, two lines can be used. The second is to make opposite vertical lines for two parallel lines at any point, and a line to pass the midpoint of the vertical line. (the figure is for the convenience of drawing two vertical lines, two parallel lines are applicable.)

6.

1. After opening CAD, we find the line option in the drawing

7. First of all, you need to know the distance between two lines, then co the endpoint of any line
and then use the from command to offset to the midpoint of the two lines

8. You can not connect the two points, hold down shift in the blank, right-click, and select between the two points. Hope to adopt!

9.

1. Use CAD to open our graphics file, and then find the data extraction option in the menu,

10.

Method:

1. select the center line, open the "properties" palette, as shown in the figure, and adjust the setting value of "linetype scale" appropriately

   

2. adjust the length of the center line appropriately, for reference< br />