Exhibition center to Lianhua North subway

1.

Bus route: no.371, about 4.4km

1. Walk about 70m from Shenzhen Convention and Exhibition Center to convention and Exhibition Center Station

2. Take no.371, after 6 stops, to flower world station 2

3

2.

Take the subway Longgang line (line 3) to the subway children's Palace Station Exit E

cross the road and go left for about 360 meters to the main entrance of Shenzhen Lianhuashan park

3. Installed, that is, all new hardware, the general recommendation to try with the original installation, no longer can not doubt the hardware problem.

4. ~~~Where did it come from~~

5.

The purpose of reloading the system is to solve the problems such as computer jam. However, if the system is often jammed after reloading, there are various reasons for this situation, so it is difficult to check. The following steps can be solved:

method 1:

< P > 1. First, I press F8 to enter the safe mode interface. But when I went in, I waited for a few minutes, but there was no response. It always showed that please wait a moment...

5. Restart the computer and then re install it in the normal way. At this time, you will find that the installation has been successfully completed

6.

Bus route: KMB 62x, 29.2km long.

1. Walk about 140m from Tuen Mun downtown to Tuen Mun central terminus.

2. Take KMB 62x, after 5 stops, to fenglilou station (or KMB 61x)

3. Walk about 840m to shanqibao (Jiulongtang station)

7. Chinese pinyin or random code
has no accurate meaning
don't get tangled in it

8. Later, after a re installation, the card does not get stuck, but after a day, it gets stuck again, and then it gets stuck again, which is indescribable
it's obvious that your hard disk is responsible for the physical damage. You can use hdtune 5.0 software to detect it, and then replace it with a new hard disk. I wish you success and have a good time.