Qunli home to Nangang District Human Resource Center

The fastest bus route from Tuen Mun Town Centre to Yuen Long is as follows. No transfer is required. The fastest time is about 30 minutes

bus line: KMB 68A, the whole journey is about 9.9 km

1. Walk about 270 meters from Tuen Mun downtown to Tuen Mun Town Hall Station

2. Take KMB 68A, after 16 stops, to Yuen Long Square Station

3. Walk about 190 meters to Yuen Long

Unit is missing α Is the angle between the X axis and

axis β Is the included angle with y axis

0 γ Is the angle between Z-axis and z-axis

< P >

< and,

< P >

< Super City

The computer reload system is stuck. Try the following methods:

1. It is recommended to restart the computer first, and then continue the installation. Generally, it can be passed

bus route: KMB B1 → West Rail Line → KMB 259D, the whole journey is about 29.7km

1. Walk about 550m from Futian port to Lok Ma Chau railway station

2. Take KMB B1, pass 5 stops, reach Xingdian I station

3. Walk about 560m, reach Yuanlang station

4. Take west rail line, pass 4 stops, reach Tuen Mun station

5, walk about 670m, Arrive at Tuen Mun central terminus

6, take KMB 259D, pass 7 stops to Meile Garden Station

7, walk about 1.1km to Tuen Mun District

The computer's re installation system is stuck. Try the following methods:
first, it is recommended to restart and then continue the installation. Generally, it can be passed
2. If the first step fails, it is recommended to replace another version of the system disk for installation
thirdly, if the above two steps are not successful, then we need to carry out troubleshooting according to the situation
the following is an analysis of several common stuck phenomena encountered in the process of installing the system (take XP as an example):
1. Set the CD to stop at the startup interface after starting, and do not enter the installation interface:
this phenomenon is mostly caused by the CD-ROM drive, CD-ROM and hard disk, and is often caused by the CD-ROM can not read and write normally, the CD-ROM drive read disk deadlock, or the hard disk itself has a hard fault, By replacing other optical disks, first test whether it is caused by the optical drive or the optical disk, shield the hard disk in CMOS, and then guide and observe it with the optical disk. If you can enter the installation interface normally, you can conclude that the hard disk is faulty
2. The CD-ROM boot enters the installation system interface and blocks after accepting the installation protocol:
that is, after the introction of installation, the hard disk partition phase will start immediately. At this time, there will be a short wait, with only a small line of English on the screen. If it crashes at this stage, 80% of it is e to the hard disk failure, Replace the hard disk directly
3. When the installation process reaches 34 minutes, it will jam:
this phenomenon mostly occurs in brand computers. When the installation process reaches 34 minutes, the video card will be detected, that is, the screen will be black for several times, but it may crash directly after a few times. This phenomenon can be basically solved by replacing the video card or memory
4. If the CPU crashes irregularly ring the installation process, check whether there is any problem in the heat dissipation of CPU:
if the CPU crashes irregularly ring the installation process, first, check the hard disk and use the hard disk detection tool to check whether there are bad tracks. MHDD detection is recommended. It is compatible with SATA hard disk and the detection speed is very fast. Most ghost system disks integrate this software. Second, check the memory and use memtest detection, Very fast and very detailed, the third direct replacement motherboard
no matter what version of the system is installed, the most likely parts to crash in the process of installing the system are the hard disk and the memory. If there is a crash, it can be basically solved by replacing these two parts