Where does Montblanc after sales center go
Publish: 2021-04-26 03:45:57
1. Professional watch maintenance company I know there is a Hangzhou Guangcheng on Qingchun Road. You can go and have a look. The address is room 2006, 20th floor, Jiade Plaza, 118 Qingchun Road. It used to be very convenient.
2. If you wear it every day, the best way to maintain it is to wind it tightly every two weeks to ensure that its gears run smoothly. Compared with those who don't wear Tissot watch frequently, they should ensure that the watch is wound at least once every two weeks to ensure the continuous operation of the watch, that is, to ensure the normal and accurate operation of the internal mechanism.
3. The quartz meter has no output signal, and other aspects are normal. The circuit board has no output signal when using the multimeter. Most of the reasons are caused by the damage of quartz vibrator or the failure of integrated circuit. If the replacement of quartz vibrator is invalid, the whole circuit board needs to be replaced Gear failure, most of them are st or foreign matter between the gear teeth, so that the gear teeth get stuck with each other. There is also a part of the surface is too much or very little oil, too much oil between the wheel, wheel and splint adhesion. Too little oil makes the resistance of the rotating gear train too large, which will make the electronic watch not go well. When encountering these faults of stepping motor and gear train, it is necessary to clean, remove foreign matters and refuel
the coil is broken e to oxidation or man-made reasons, which can be detected by the multimeter test and generally needs to be replaced. The battery of quartz meter has no power or insufficient capacity and needs to be replaced with a new one. But the pointer quartz electronic watch often finds that the battery has no power in a short time, which is generally caused by high power consumption or poor quality of the battery itself. In this case, we should first find out the reason, remove the fault, and then replace the new battery. Contact is not good, most of the positive and negative contact reed on the dirt, poor contact with the battery. The contact between the signal output point on the circuit board and the lead out point of the coil wire head will also have poor contact. All these will cause the circuit not to conct and make the quartz electronic watch not to go or not to go well. If you find that the circuit is blocked e to poor contact, first clean the contact surface thoroughly, and then reassemble it. The stepper motor can not rotate. The rotor of the stepper motor is a permanent magnet, which is often stuck with the stator e to the adsorption of iron filings, causing the quartz watch pointer to stop or stop.
the coil is broken e to oxidation or man-made reasons, which can be detected by the multimeter test and generally needs to be replaced. The battery of quartz meter has no power or insufficient capacity and needs to be replaced with a new one. But the pointer quartz electronic watch often finds that the battery has no power in a short time, which is generally caused by high power consumption or poor quality of the battery itself. In this case, we should first find out the reason, remove the fault, and then replace the new battery. Contact is not good, most of the positive and negative contact reed on the dirt, poor contact with the battery. The contact between the signal output point on the circuit board and the lead out point of the coil wire head will also have poor contact. All these will cause the circuit not to conct and make the quartz electronic watch not to go or not to go well. If you find that the circuit is blocked e to poor contact, first clean the contact surface thoroughly, and then reassemble it. The stepper motor can not rotate. The rotor of the stepper motor is a permanent magnet, which is often stuck with the stator e to the adsorption of iron filings, causing the quartz watch pointer to stop or stop.
Hot content