Installation of mining machine fan
What miner are you talking about? Is it the S9 of bitcoin ant miner
if your miner is a small ant series miner, you can rece the noise by changing the fan and appropriately recing the chip frequency. But it's still very difficult to keep quiet.
if you have a large amount of electricity, you can choose a professional hosting mine company for hosting. The electricity charge will be cheaper than that of residents, and you don't need to worry about noise problems, which will cause complaints from neighbors.
if you need anything, you can send a private letter to me
the second method is: if the fan has a shaft core which can be oiled, it can be removed, the st on it can be cleaned thoroughly, and then a proper amount of engine oil can be dropped into the shaft core of the fan, so that the fan can operate normally after operation.
1. Before the installation of the seat type drawing machine, the on-site foundation shall be compared with the drawing of the drawing machine. After the inspection, the steel plate shall be embedded. The thickness of the steel plate shall be 20 mm and the flatness shall not be greater than 1.5%
2. After the ore drawing machine is installed, adjust the relative position, and then weld the spring base and the embedded steel plate by spot welding
3. It is required that the two vibrating motors must turn in the opposite direction
4. After installation and running for 1 hour, check whether the body runs smoothly, the yaw is not more than 0.5mm, and the bolt fastening of the vibration motor
5. If the handling capacity is not enough, the exciting force of the vibration motor can be adjusted to achieve the best effect if it is allowed
6. Adjustment of exciting force: A. remove the protective cover; B. loosen the two inner eccentric blocks; C. adjust the two outer eccentric blocks in the same phase and at the same angle; D. tighten the adjusting bolts and install the protective cover; e. the temperature rise of the vibration motor bearing shall not be greater than 80oC (resistance method)
7. During the operation of the ore drawing machine, attention should be paid to whether the movement of the machine body is stable. If abnormal operation or abnormal sound is found, the machine should be stopped immediately for inspection. 8. The bearing of vibration motor shall be lubricated with 3 # lithium grease once a week. The bearing shall be inspected and cleaned once a year to check the wear degree of the bearing. If necessary, it shall be replaced and repaired in time
9. The fastening bolts of the connection parts should be checked frequently to eliminate the hidden danger in time
1. This is a 12cm fan. The chassis needs corresponding holes. It's OK to replace the CPU or install it
2, 12V 2.3A belong to violent fan, the noise is very big, but the air volume is enough, not too noisy can be considered. To overclock CPU is still very useful
3. Finally, pay attention to the power supply. Some motherboards have three or four pins, which may not bring 12V 2.3A.