Polar route 4 enhanced plate miner
A few days ago, I chatted with Jirou Yida and asked him about it. I would like to quote his statement:
-
the antenna uses Rogers high frequency antenna special plate. People who are familiar with the instry know that the conversion efficiency and gain of Rogers antenna are not comparable to that of ordinary antenna. In addition, the price of Rogers plate is not comparable to that of ordinary antenna, and the cost is basically 2-3 times different. Therefore, Rogers antenna is only used on the 1000 yuan router of Linksys and Netware
-
with the hardware network to accelerate Hnat, the underlying software has been fully optimized, and the measured results, whether from wired to wired or wired to wireless, live up to the name of full Gigabit, almost no loss; It's a perfect match to use with light cat
-
make full use of the large memory of 256mddr2, realize the al ROM rendancy backup in 128mnand, make the system more stable
-
with the powerful computing power of al core CPU and Hnat, the signal delay is specially optimized, and the game experience is obviously optimized
-
USB3.0 is available in the last generation of G4, which is suitable for full Gigabit port
The specific difference between the enhanced version of pole Route 4 and pole 4:
-
the enhanced version of pole Route 4 has been fully upgraded in performance and experience. It adopts full gigabit network port + USB 3.0 interface, becoming a powerful tool for Gigabit bandwidth
-
with bidirectional convection heat dissipation fence technology, the internal air flow is as high as twice that of ordinary router, which can easily cope with the network mode of long-time high-speed transmission. In addition, through the whole board cooling hole at the bottom, pole Route 4 upgrade can conct heat conction for the internal chip close to the desktop, which is known as the fastest passive cooling router
-
with a higher integrated antenna hidden design, the router maintains a simple appearance design. At the same time, four fine copper 5dBi antennas are set on the fuselage to realize fast data transmission and wider signal coverage
-
in terms of specifications, it is equipped with al core 580mhz processor, the flash memory is increased to 128MB, the memory is increased to 256MB, and it supports hundreds of plug-ins
-
in addition, the enhanced version of polar route 4 is equipped with al USB interfaces (USB 2.0 + USB 3.0), which can connect two USB mass storage devices and become a home data center
-
equipped with geeturbo 3.0 intelligent algorithm kernel, it can bring more stable network transmission according to different home environment, and can grasp the distance between network equipment and router in real time, and the polar route will re match the best signal strength every time it moves< br />
A few days ago, I chatted with Jirou Yida and asked about it. I would like to tell you something about it:
< UL >the antenna uses Rogers high frequency antenna special plate. People who know well know that the conversion efficiency and gain of Rogers antenna are not comparable to that of ordinary antenna. In addition, the price of Rogers plate is not comparable to that of ordinary antenna, and the cost is basically 2-3 times different. Therefore, Rogers antenna is only used on the 1000 yuan router of Linksys and Netware
with the hardware network to accelerate Hnat, the underlying software has been fully optimized, and the measured results, whether from wired to wired or wired to wireless, live up to the name of full Gigabit, almost no loss; It's a perfect match to use with light cat
make full use of the large memory of 256mddr2, realize the al ROM rendancy backup in 128mnand, make the system more stable
with the powerful computing power of al core CPU and Hnat, the signal delay is specially optimized, and the game experience is obviously optimized
USB3.0 is available in the last generation of G4, which is suitable for full Gigabit port
pole Route 4 uses al core mips1004kc 880mhz MediaTek mt7621 processor,
the performance can reach about twice of pole route 3pro's single core mips24kc 580mhz MediaTek mt7620 processor
pole Route 4 is a Gigabit switch built in the processor, which is more efficient than the external switch chip of pole route 3pro.
in other words, pole Route 4 is more stable and more comfortable when using more than 200m optical broadband,
the main advantage of pole route 3pro is that the all metal body is more advanced than that of pole route 3pro, which supports intelligent networking, and other aspects are better than pole Route 4.
the enhanced version of pole Route 4 is a medium and high-end router chip of mt7621a al core 880mhz mips1004kc architecture
pole routing 3 Pro is the mainstream market (middle and low end) router chip of mt7620 single core 580mhz MIPs 24kc architecture
although pole routing 3pro is also a full Gigabit Wan LAN port, it is actually completed by mt7620 processor and external Gigabit switch,
and pole routing 4 enhanced version is mt7621 chip, which originally supports Gigabit ports, with higher efficiency and stronger performance
for reference, refuse to , original answer.
if you only need 2.4G, then Jiyi s is the best for you
if you want a precursory router, there is no doubt that it is polar route 4
I have been using polar route 4 for two months, and it is very stable and the signal is very good
after trying for a period of time, glory route gave up without some interesting functions