Position: Home page » Pool » Open pit excavator cycle operation time

Open pit excavator cycle operation time

Publish: 2021-05-05 05:29:47
1. 1. The poor terrain environment of the mine
the site must be observed before the operation. The mine is located in the high altitude area, with many ramps and sharp bends, so the requirements for the operator are relatively high. In addition, the roads of small private mines are relatively narrow, and there are no stone lined roads. They are all dirt roads, so they can't walk in the rainy season. The picture above is the scene of the open-pit mine project. Special attention should be paid to safety when driving excavators here
2. There are many hidden dangers of excavators responsible for stripping operation
for excavators responsible for stripping operation in mines, they often work on the top of the mountain, which has a high risk index. The mining team and the slag transportation team should try not to be in the same line, otherwise it will be troublesome to roll down the stone. In addition, the excavator responsible for stripping ring mining should not be too many, otherwise the hidden danger is too big
3. Rock excavation in the mine does great harm to the bucket
excavator working in the mine is different from other places, such as digging hard rock in the mine, which does great harm to the bucket. The operators should operate the bucket correctly, adjust the position of the excavator according to the direction of the rock crack, so that the bucket can shovel in smoothly. The force should not be too strong when digging, and the tooth root is easy to break
4. Always obey the command of the safety officer
the safety officer in the mine is also essential. Mining and stripping need at least two safety officers to cooperate, and need to be equipped with whistles and walkie talkies, because the excavator driver can't observe the situation of the rear slope and the surrounding at any time, and the safety officer needs to observe at the highest point. If no one commands, it is dangerous for the rock to fall, This is also one of the hidden dangers of mine safety
5. At the same time of mining, slope repair should be carried out along the way.
open pit mining has the characteristics of heavy workload and many potential safety hazards. Excavator in mining at the same time, but also by the way to repair the slope, because some slope you first repair is not good, to the back to repair it is very difficult. The purpose of repairing the slope is to rece the occurrence of rolling stones and landslides, which requires higher requirements for the manipulator
6. Don't listen to the sound when loading the truck.
when the excavator is working on the slope, you need to pay more attention all the time. Don't turn on the sound in the car or listen to the music. Under the vibration of the excavator in large mines, the loose mud and stones above may be shaken down. If you play it too loud, you can't hear the commander's command or other problems
7. Pay attention to the falling stones after blasting operation
blasting operation is often carried out in mines. Special attention should be paid to safety after blasting, and all-round inspection should be carried out in advance to see if there are loose stones that are about to fall or empty joints caused by blasting. The operator should pay attention to safety, and excavate and mp before entering the working area.
2. 1. The poor terrain environment of the mine < br > before operation, the site must be observed. The mine is located in a high altitude area, with many ramps and sharp bends, so the requirements for the operator are relatively high. In addition, the roads of small private mines are relatively narrow, and there are no stone lined roads. They are all dirt roads, so they can't walk in the rainy season. The picture above is the scene of the open-pit mine project. Special attention should be paid to safety when driving excavators here< Br > 2. There are many hidden dangers of excavators responsible for stripping operation < br > for excavators responsible for stripping operation in mines, they often work on the top of the mountain, which has a high risk index. The mining team and the slag transportation team should try not to be in the same line, otherwise it will be troublesome to roll down the stone. In addition, the excavator responsible for stripping ring mining should not be too many, otherwise the hidden danger is too big< Br > 3. Rock excavation in mines does great harm to the bucket < br > excavators working in mines are different from other places, such as digging hard rock in mines, which does great harm to the bucket. The operators should operate the bucket correctly, adjust the position of the excavator according to the direction of the rock crack, so that the bucket can shovel in smoothly. The force should not be too strong when digging, and the tooth root is easy to break< < br > 4. Always follow the direction of the safety officer < br > the safety officer in the mine is also essential. Mining and stripping need at least two safety officers to cooperate, and need to be equipped with whistles and walkie talkies, because the excavator driver can't observe the situation of the rear slope and the surrounding at any time, and the safety officer needs to observe at the highest point. If no one commands, it is dangerous for the rock to fall, This is also one of the hidden dangers of mine safety< The open pit mine has the characteristics of heavy workload and many potential safety hazards. Excavator in mining at the same time, but also by the way to repair the slope, because some slope you first repair is not good, to the back to repair it is very difficult. The purpose of repairing the slope is to rece the occurrence of rolling stones and landslides, which requires higher requirements for the manipulator< Br > 6. Don't listen to the sound when loading the truck. < br > when the excavator is working on the slope, you need to pay more attention all the time. Don't turn on the sound in the car or listen to the music. Under the vibration of the excavator in large mines, the loose mud and stones above may be shaken down. If you play it too loud, you can't hear the commander's command or other problems< Br > 7. Pay attention to the falling stones after blasting operation < br > blasting operation is often carried out in mines. Special attention should be paid to safety after blasting, and all-round inspection should be carried out in advance to see if there are loose stones that are about to fall, or virtual joints caused by blasting. The operator should pay attention to safety, and the excavator and self unloading can enter the working area after ensuring safety.
3. Input setup to graphically configure each item of eth0
and then ifup eth0 starts the network card
ifconfig to check whether there is eth0
4. Generally speaking, alo is definitely the strongest, but it is also the most difficult to do (HONGNA and Youji are too difficult to do), Sao is the second, GGO is the best (you can brush out a lot of ten strokes each time)
the strongest alo is because a round of damage will result in a lot of debuffs, However, when you meet the head of the team, you can ask for your own blessing (the head's big move seems to be immune to adverse effects). In addition, a sip of silika milk can clear the adverse effects, so the formed Sao has a certain degree of restraint on the alo formation. But there are also some abnormal characters in alo, such as Eugene, whose burns are too painful and very easy to get. There is also an Oberon, whose damage is super high
GGO. Because I don't play, I don't know the details. I only know that it's probably people like Sela Xe, the shinaitongzi beast. Tongzi's shield is very thick, and the output of the beast is also good, The biggest advantage of GGO is to blow the head, directly decting a quarter of the blood, but still afraid of the head's anti injury...
it is recommended that you download the "national mobile game strategy for swords divine domain strategy app", which contains many strategies, very useful, I hope to help you!
5.

Swordsman in black, do you want to know more about swordsman in black? The following small series to give you a detailed answer, want to understand the players come strong onlookers

Which of the three teams of swordsmen in black is better? How to choose? In the game, it is a lineup composed of three worlds: Sao / alo / GGO. So, for novice players, they don't know the three worlds, and they don't know how to choose well? So, the following ironbone small make-up is here to analyze the advantages and disadvantages of the three teams

Sao lineup: it has a strong balance, and it has a strong strike ability against the meat and the front row. The early damage is not as high as the other two lineups, which is the weakness. The coefficient of blood return is relatively high. It has the best strike effect for the enemy with super high defense, and is suitable for fighting consumption (relatively expensive)

2 Alo lineup: Group damage is relatively high, there are many control skills, suitable for fighting multiple enemies, played a good harassment tactics, mainly depends on the face (see luck, civilian players must)

0 GGO lineup: the damage of single unit is explosive and explosive. (the premise is that you have to take the lead, otherwise it is easy to be destroyed by the group). For the enemy with high blood, it has explosive damage and is suitable to play explosive lineup (it also depends on the face, whether there is a burst, it is also more expensive)

GGO lineup has explosive damage The above is about the swordsman in black, which of the three worlds is better? How to choose all the content, players can start from their own combat characteristics and actual situation, to select the best training lineup. More game strategy, all in the iron bone net zone

6. There are three worlds among the swordsmen in black in the realm of sabre and sword: Sao, alo and GGO. If it's comics or animation fans, they should have a better understanding of these three worlds. For most players, these three worlds are not so familiar. Although they can form teams together, it's still recommended that you try to use the characters of the same world in the future lineup
as for the roles of swordsmen in black in sword God domain, it varies from person to person and everyone has different experience. I suggest you download a nationwide mobile game strategy for swordsmen in black in sword God domain app. This is what I use. It has the latest strategy and the latest information of the game.
7.

Top 5, Sao yasna

{rrrrrrr}

I believe many people have guessed that, yes, the first is Eugene! As an orange card, Eugene's two skills are above the average level, and his must kill skill is even more amazing. It's a super must kill skill that integrates AOE + all dot - + single high explosive. It's hard to describe

is more awesome in terms of fetters. Even if there is no Lifa at present, the fetters of Eugene + plastic night + Tongren + Sinai are among the best. As the representative role of alo world, it's right to choose him! The most important thing is that Eugene's acquisition method is too civilian, civilian players preferred

summary: character strength 9, lineup 10, starting difficulty 3

I hope this answer is helpful to you

Hot content
Inn digger Publish: 2021-05-29 20:04:36 Views: 341
Purchase of virtual currency in trust contract dispute Publish: 2021-05-29 20:04:33 Views: 942
Blockchain trust machine Publish: 2021-05-29 20:04:26 Views: 720
Brief introduction of ant mine Publish: 2021-05-29 20:04:25 Views: 848
Will digital currency open in November Publish: 2021-05-29 19:56:16 Views: 861
Global digital currency asset exchange Publish: 2021-05-29 19:54:29 Views: 603
Mining chip machine S11 Publish: 2021-05-29 19:54:26 Views: 945
Ethereum algorithm Sha3 Publish: 2021-05-29 19:52:40 Views: 643
Talking about blockchain is not reliable Publish: 2021-05-29 19:52:26 Views: 754
Mining machine node query Publish: 2021-05-29 19:36:37 Views: 750