How to connect the miner to the power supply

1. Special power supply

such as quanhan fsp1600w rated power mining special power supply
the output ports of special power supply for mining machine all adopt 6pin interface, all of which are 12V output, and 5V and 3.3V power supply input in 24pin are cancelled

2. If the power supply is broken, replace it directly. It must be because the power supply is broken, the output current is unstable or the output current is unstable. The function of the power supply is to convert alternating current into direct current. Half of it is not repaired, and it is not expensive. Just buy a new one

3. Is it one of the following games, StarCraft, red alert, Warcraft, Empire

4. Now bitcoin is out of business. The risk is high

5. Campus network multi-purpose IPv6 ecation network or LAN access, the upper layer without operator equipment filtering, few firewalls, almost all ports exposed in the WAN environment, easy to attack

6. Yes, they all need power supply. If the power supply is insufficient, the graphics card will not be detected

7. Grounding wire is for safety, not grounding will not affect the normal use

8. If you want to use the switching power supply of the computer for other purposes, you can change it as follows:
1. Open the iron box of the power supply, take out the circuit board from the box, and use a brush to remove the st
2. Find the key components. Including: power oscillation integrated block, optocoupler, 12V voltage regulator, pulse width adjusting potentiometer, etc. Find the information of power supply mole
3. First, change the 12V voltage regulator into 15V, and find the pulse width adjustment circuit according to the data of power supply integrated block. Some power supplies do not design power supply fine-tuning, but fixed resistance. Remove the fixed resistance, and connect a potentiometer whose resistance value is basically close to the welding resistance on the two solder joints. Now adjust the resistance of the potentiometer to the maximum
4. Use a multimeter to monitor the 12 V power supply port, turn on the power supply, slowly rece the resistance of the potentiometer, observe the voltage change, and adjust it to 15 v. After stabilization, observe for a little time and connect the false load toaster
5. After it is accurate, measure the resistance of the potentiometer and replace it with a fixed resistance with the same resistance.