Vibration drawing machine manufacturers which good
Vibrating feeder: if the ore is evenly broken, small in size and good in fluidity, swing type or wave type can be selected. It is suitable for elliptical vibration type and directional vibration type
double mass vibrating feeder: the principle of double mass near resonance inertial vibration is adopted. Single row or double row shear rubber springs are arranged at the top and bottom, and the lower pressing plate is connected to the balance body by bolts, and then the left and right side plates are connected with the groove body. It has compact structure, stable starting under constant pressure, and is not affected by the load and jamming of the tank material. The feeding particle size (0-850mm) is large (8-1800t / h). It can be equipped with stepless frequency converter to realize frequency conversion feeding and batching, and remote microcomputer operation and control
1. Before the installation of the seat type drawing machine, the on-site foundation shall be compared with the drawing of the drawing machine. After the inspection, the steel plate shall be embedded. The thickness of the steel plate shall be 20 mm and the flatness shall not be greater than 1.5%
2. After the ore drawing machine is installed, adjust the relative position, and then weld the spring base and the embedded steel plate by spot welding
3. It is required that the two vibrating motors must turn in the opposite direction
4. After installation and running for 1 hour, check whether the body runs smoothly, the yaw is not more than 0.5mm, and the bolt fastening of the vibration motor
5. If the handling capacity is not enough, the exciting force of the vibration motor can be adjusted to achieve the best effect if it is allowed
6. Adjustment of exciting force: A. remove the protective cover; B. loosen the two inner eccentric blocks; C. adjust the two outer eccentric blocks in the same phase and at the same angle; D. tighten the adjusting bolts and install the protective cover; e. the temperature rise of the vibration motor bearing shall not be greater than 80oC (resistance method)
7. During the operation of the ore drawing machine, attention should be paid to whether the movement of the machine body is stable. If abnormal operation or abnormal sound is found, the machine should be stopped immediately for inspection. 8. The bearing of vibration motor shall be lubricated with 3 # lithium grease once a week. The bearing shall be inspected and cleaned once a year to check the wear degree of the bearing. If necessary, it shall be replaced and repaired in time
9. The fastening bolts of the connection parts should be checked frequently to eliminate the hidden danger in time
blockchain is an important concept of bitcoin, which is essentially a decentralized database and the underlying technology of bitcoin. Blockchain is a series of data blocks generated by cryptography. Each data block contains the information of a bitcoin network transaction, which is used to verify the validity of the information (anti-counterfeiting) and generate the next block
global currency has never been heard of, and there is no relevant report in the mainstream media. However, the recent decent project is quite popular.
Vibrating ore drawing machine is a kind of vibration type inertial vibration ore drawing equipment with vibration motor as excitation source. It is an ideal equipment for ore and other materials discharging, feeding or loading. Compared with other types of ore drawing machine, vibration ore drawing machine has the following advantages: energy saving, high ore drawing efficiency, even ore drawing and easy control
model classification variant manufacturing
General Type: open type, used for general feeding without special requirements
sealed type: simply speaking, the feeding trough with cover is used for feeding materials with large st
speed regulation type: used for automatic weighing.