Silencing of mine machine can

1. In this case, resonance is generated at low speed, and the resonance is transmitted to two objects to generate sound. There are two possibilities to generate sound. One is only the sound generated by the iron skin or muffler on the exhaust pipe, and the other is the resonance sound generated by the looseness of the chassis. Take a look at the SAIC repair rack.

2. It's not the exhaust pipe, is it? Or the muffler is broken, you find a place to have a look

3. There are three kinds, one is made of pop can, which can be used for 10 times; One is a simple muffler made in the workshop, which can be used for 30 times; The best is the military muffler, which can be used 50 times; It's hard to find. There's usually a police station or a gun store

4. Can crusher
many people do this, but they don't do it the same way
it's not machines that make money, it's people that make it

5. The operation method of the can crusher is as follows: 1. After the can crusher is installed according to the requirements of the manual, it should be idled for 7-8h, and then 12-16h load test should be carried out after it is normal. During the load test, the berthing temperature should not exceed 50-60 ℃. 2. Before starting the can crusher, check whether ore is stuck in the crushing chamber, whether the width of the ore mouth is appropriate, the oil star and oil temperature in the oil tank (not less than 20 ℃ in winter), supply water to the water seal and check the drainage condition (the water supply should not be too large). 3. To start the crusher, start the oil pump and supply water to the cooler. The oil pressure is generally 0.8-1.5k8/cm2, and the cooling return water pressure is 0.5k8/cm2 lower than the oil pressure. 4. The oil pump operates normally for 3-5mtn, and the crusher can be started after the return oil is normal. After idling for 1-2mir and everything is normal, the feeding can be started. 5. The feeding and distribution to the crushing cavity should be uniform, so as to prevent the uneven wear of the lining plate from affecting the proct quality, and strictly prevent the material from feeding into the crushing cavity from one side. 6. Regularly check the slope of crushed procts, regularly measure and adjust the discharge port to ensure the proct particle size requirements. 7. When the can crusher stops, stop the feeder first, stop the crusher after the ore in the crushing chamber is completely discharged, and finally stop the oil pump. If you are a customer of metal crusher, or you have any problems in the use of metal crusher, we will provide you with free professional solutions for the application of metal crusher! Call now to learn more. I believe the communication with "Xinxing" people will be helpful to your choice! You can also visit our website: www.gyxxps.com Gongyi Xinxing Machinery Factory

hopes to adopt