Miner plate power supply

1. Is it one of the following games, StarCraft, red alert, Warcraft, Empire

2. Now bitcoin is out of business. The risk is high

3. Superposition principle: when each independent power source acts on the circuit separately, other power sources must be set to zero, that is, voltage source short circuit (output voltage is zero), current source open circuit (output current is zero)

4. If you want to use the switching power supply of the computer for other purposes, you can change it as follows:
1. Open the iron box of the power supply, take out the circuit board from the box, and use a brush to remove the st
2. Find the key components. Including: power oscillation integrated block, optocoupler, 12V voltage regulator, pulse width adjusting potentiometer, etc. Find the information of power supply mole
3. First, change the 12V voltage regulator into 15V, and find the pulse width adjustment circuit according to the data of power supply integrated block. Some power supplies do not design power supply fine-tuning, but fixed resistance. Remove the fixed resistance, and connect a potentiometer whose resistance value is basically close to the welding resistance on the two solder joints. Now adjust the resistance of the potentiometer to the maximum
4. Use a multimeter to monitor the 12 V power supply port, turn on the power supply, slowly rece the resistance of the potentiometer, observe the voltage change, and adjust it to 15 v. After stabilization, observe for a little time and connect the false load toaster
5. After it is accurate, measure the resistance of the potentiometer and replace it with a fixed resistance with the same resistance.

6. Don't ask. Your family is the best

7. Unknown_Error

8. Unknown_Error