Miner rendering OC

bitcoin was obtained by CPU in the early days. With the continuous development of GPU speed and the emerging advantages of GPU general computing, miners graally began to use GPU instead of CPU for mining. Bitcoin mining uses SHA-256 hash operation, which will carry out a large number of 32-bit integer cyclic right shift operation. Interestingly, this algorithm operation can be implemented by a single hardware instruction in AMD GPU, while it needs three hardware instructions to simulate in NVIDIA GPU. This one alone brings an additional 1.7 times of computing efficiency advantage for AMD GPU. With this advantage, amd GPU is favored by the majority of miners

advise the landlord not to dig up if the budget is not too much!!! This money is not earned if you want to

the difficulty of bitcoin is increasing. Mining with graphics card is a race against time. The main reason is that the difficulty of mining bitcoin is graally increasing (the reason of bitcoin algorithm design). If a set of platforms can get 1 bitcoin per day according to the current difficulty, then in one month, the platforms with the same computing power will only get 0.8 bitcoins, even the top graphics cards will get 18.2 days (which can't be shut down), and the lowest second-hand hd7750 will need more than 400 (it will take 214 days to get one). Just look at this figure (this is the data in May this year, Now it's more than 18 days)

people can earn money by buying several mining machines (mining machines with dozens of top graphics cards piled together)

I hope I can help you

1. Before the installation of the seat type drawing machine, the on-site foundation shall be compared with the drawing of the drawing machine. After the inspection, the steel plate shall be embedded. The thickness of the steel plate shall be 20 mm and the flatness shall not be greater than 1.5%
2. After the ore drawing machine is installed, adjust the relative position, and then weld the spring base and the embedded steel plate by spot welding
3. It is required that the two vibrating motors must turn in the opposite direction
4. After installation and running for 1 hour, check whether the body runs smoothly, the yaw is not more than 0.5mm, and the bolt fastening of the vibration motor
5. If the handling capacity is not enough, the exciting force of the vibration motor can be adjusted to achieve the best effect if it is allowed
6. Adjustment of exciting force: A. remove the protective cover; B. loosen the two inner eccentric blocks; C. adjust the two outer eccentric blocks in the same phase and at the same angle; D. tighten the adjusting bolts and install the protective cover; e. the temperature rise of the vibration motor bearing shall not be greater than 80oC (resistance method)
7. During the operation of the ore drawing machine, attention should be paid to whether the movement of the machine body is stable. If abnormal operation or abnormal sound is found, the machine should be stopped immediately for inspection. 8. The bearing of vibration motor shall be lubricated with 3 # lithium grease once a week. The bearing shall be inspected and cleaned once a year to check the wear degree of the bearing. If necessary, it shall be replaced and repaired in time
9. The fastening bolts of the connection parts should be checked frequently to eliminate the hidden danger in time