How to restore the factory of ant mining machine S7
Publish: 2021-04-23 14:01:35
1. Ant miner efficiency, that is to say, this thing can't work, can't use, don't support.
2. The temperature is too high: one of the double fans is not running, or the speed cannot reach.
3. Certainly. We are members of consensys blockchain. The members of consensys blockchain mainly cooperate in expanding social impact. A number of blockchain projects are working together for the sustainable development goals of the United Nations. Aeternity is an investor in Kora. We will announce the details of the cooperation between KORA and stellar soon. Please look forward to it!
4. Like Odin mining machine, the cost of computing power acquisition of early participants is very low and the difficulty is small. The more people involved behind, the more difficult it is to dig.
5. There is something wrong with the mobile phone system. Reset down the normal management of the phone is good
just download app and Google software first
connect the mobile phone to the computer, select the stable setting of the tool, and the mobile phone will be OK
click the mobile phone system upgrade version on the mobile phone to set it to the latest one
that will ensure that the mobile phone is updated to the latest version
in this way, you can enter the management interface and operate normally.
just download app and Google software first
connect the mobile phone to the computer, select the stable setting of the tool, and the mobile phone will be OK
click the mobile phone system upgrade version on the mobile phone to set it to the latest one
that will ensure that the mobile phone is updated to the latest version
in this way, you can enter the management interface and operate normally.
6. Installation of ant protection board app, only support Android protection board calibration:
1. Unit voltage calibration: by adjusting the "system reference voltage" (about 3.0 by default), slowly increase and decrease the amplitude of 0.001, the unit voltage value can be changed until it is accurate! 2. Total voltage calibration: by adjusting the "total voltage ad value into the actual voltage of the parameters" (default about 3330), slowly adjust the size of this value, you can change the total voltage until accurate! 3. Current calibration: by adjusting the "current sensor range", slowly adjust the value, you can change the current until it is accurate
note: please do not change the item of "power starting current" in parameter setting, too large may lead to MOS tube burning and discharging!!!
1. Unit voltage calibration: by adjusting the "system reference voltage" (about 3.0 by default), slowly increase and decrease the amplitude of 0.001, the unit voltage value can be changed until it is accurate! 2. Total voltage calibration: by adjusting the "total voltage ad value into the actual voltage of the parameters" (default about 3330), slowly adjust the size of this value, you can change the total voltage until accurate! 3. Current calibration: by adjusting the "current sensor range", slowly adjust the value, you can change the current until it is accurate
note: please do not change the item of "power starting current" in parameter setting, too large may lead to MOS tube burning and discharging!!!
7.
As shown in the figure, 
the reset button is located on the right side of the network port, next to the red and green lights
after the machine is powered on, wait 2 minutes for the miner to start up, press and hold the reset button for 10 seconds (gently poke in with a pen or toothpick, and the hand can't reach the position), release the power, and then power on after 1 minute
the IP address of S7 mining machine is reset
Hot content