How to take the miner off the shelf without damaging the machine
2. Log in the miner (Avalon, roasted cat, ant, miner of different brands and models have different IP addresses. If you find the model, search online), delete the old mine pool in the configuration interface, and fill in the new mining address and miner name
3. Log in to the f2pool miner interface and observe the calculation power. If there is no calculation power, check whether the second step is correct (be sure to delete the previous one, otherwise you are working for others)
There is a flat head screw at the bottom of carburetor, which can be unscrewed
carburetor is a key part of engine, small changes may affect vehicle performance. Therefore, in the process of carburetor disassembly, appropriate tools should be used, and the force should be moderate, so as to prevent the deformation of parts. The disassembled parts should be placed in order in order to prevent missing or wrong assembly
in the process of cleaning the carburetor, if more deposits are found in the float chamber of the carburetor, it is often caused by the failure of the gasoline filter. At this time, the gasoline filter should be checked. If the failure is confirmed, the gasoline filter should be cleaned or replaced
extended information:
precautions:
1. Carburetor is a key part of engine, small changes may affect the vehicle performance. Therefore, in the process of carburetor disassembly, appropriate tools should be used, and the force should be moderate, so as to prevent parts from deformation. The disassembled parts should be placed in order in order to prevent missing or wrong assembly
2. The carburetor should be cleaned in a clean place, the outer surface of the carburetor should be cleaned, and the internal parts can be cleaned with special cleaning agent for carburetor or instrial gasoline. In addition to impurities, pay attention to clean the gasoline gum on the surface of parts
3. Clean the cleaned parts with compressed air, and do not wipe them with cloth or paper that may cause burr to prevent re pollution. It is forbidden to poke the blocked small hole with steel wire and other hard objects to prevent the change of carburetor performance caused by changing the aperture. Gasoline or compressed air should be used to wash out
bitcoin mining machine scam is to make money by leasing or selling mining machines the so-called "mining machine" refers to the computer that installs and runs specific software and algorithms. As we all know, bitcoin can only be obtained through long-term running algorithm of computer, and the total amount is limited. Therefore, some manufacturers have launched specially designed and optimized computer procts, known as "mining machine" in January 2018, a mining computer named "Kodak kashminer" appeared at the international consumer electronics exhibition in Las Vegas, which aroused people's attention. But now critics point out that the mining machine plan is actually a fraud, and the publicity for profit is also false precautions: 1. The general computer configuration of bitcoin household can not meet the requirements of bitcoin miner, so it is difficult to earn the electricity cost of a day 2. If you have to use bitcoin mining machine to dig coins, it is suggested to choose a reliable and legal platform to go more steadily. In the legal platform mining, the daily income can be seen, and a certain amount can be withdrawn
lift up the spiral of the classifier immediately after parking to avoid being pressed. If it belongs to the ball mill cylinder leakage, the feeding should be stopped first. If the time is too long, start the mill every 5-7 minutes to deal with the return sand of the classifier. Otherwise, the feeder may be crushed by the return sand and cannot be started again. At the same time, the water supply of the classifier should be stopped first, otherwise, the coarse particles will settle rapidly e to the dilution of the slurry, resulting in more sand returning and affecting the fastening screw of the cylinder
before starting the grinding machine, it is necessary to check whether the return sand groove is blocked by the return sand and whether the transmission parts are in good condition. The grinding machine can be started only when the oil pressure reaches the specified requirements and the oil flow of the front and rear big tiles is smooth. If the shutdown time is too long or the mill is started after maintenance, the crane should be used to turn the mill to prevent damage to the motor
[Henan Sinoma cement equipment] answers for you.