How to become a miner

IPFs is a file transfer protocol similar to http. If IPFs wants to run, it needs many computers (storage devices) in the network as nodes. In a broad sense, all participating computers can be called IPFs mining machines

in order to attract more users to join the IPFs network and contribute to the network, an encryption currency named filecoin is designed, which is distributed to the participants (nodes) as a reward according to the amount of contributed storage space and bandwidth. In a narrow sense, the computer specially designed for the purpose of obtaining the filecoin reward is called IPFs mining machine

because IPFs network needs storage space and network bandwidth, in order to obtain the highest profit ratio, IPFs mining machine usually strengthens the storage space and reces the power consumption of the whole machine. For example, more than 10 high-capacity hard disks are equipped, Gigabit or higher speed network cards are equipped, and ultra-low power architecture processors are used

of course, the mining machine provides storage services, so it can obtain revenue. The size of revenue is related to the configuration of mining machinery and the number of IPFs mining machinery

extended data

the reasons why it is not recommended to invest in IPFs are as follows:

1. IPFs technology is too early to be commercialized

IPFs now takes up a lot of bandwidth. IPNs is very slow at present, which is an obvious technical defect. It will be very difficult to realize dynamic web pages only through IPFs

as a very cumbersome decentralized protocol, it is difficult for users to share files autonomously and spontaneously. In addition, even if users share files into the protocol, the files will be completely open and users cannot delete files effectively, so the security of valid files is threatened

the solution is to introce encryption and blockchain incentive mechanism. At the same time, it solves the security and storage power problems of files. However, as mentioned before, any node with workload proof under blockchain incentive mechanism will face an economic problem of continuous power on state

IPFs is quite limited, and the project interaction speed realized by IPFs protocol is also very slow. Of course, it has a direct relationship with the number of nodes and the distance of calling

1. First of all, connect the network cable, plug the network cable into the network cable interface of the mining machine, and remember to plug it tightly. Only when the miner is connected to the Internet, there is no limit to the broadband

extended data

users can buy bitcoin, at the same time, they can also use computers to "mine" bitcoin according to a large number of calculations. When users "mine" bitcoin, they need to use the computer to search for 64 bit numbers, and then compete with other gold miners by repeatedly solving puzzles to provide the required numbers for the bitcoin network. If the user's computer successfully creates a set of numbers, then they will get 25 bitcoins

e to the decentralized programming adopted by the bitcoin system, only 25 bitcoins can be obtained every 10 minutes, and by 2140, the maximum number of bitcoins in circulation will reach 21 million. In other words, bitcoin system is able to achieve self-sufficiency, resist inflation through coding, and prevent others from destroying these codes

1. First of all, use stones or other blocks to place them as shown in the figure

Step 1: first invert a transmitter, head down

Step 2: make a red stone stroboscopic device nearby

Step 3: connect the red stone stroboscopic device with the transmitter

Step 4: dig a hole directly below the emitter mouth (after LZ test, dig six spaces)

Step 5: load ammunition, turn on the switch Note: this kind of stroboscope is just in the on state when it is made. Put a switch or knock off a red stone to make the stroboscope close)