What does miner 16t mean

1. Rated computing power: 16t
power consumption on the wall: 1400W
New BTC miner, with a daily coin digging amount of 0.0007501, and a daily income of about 32 yuan / yuan according to the current coin price in 18 years

2. 1T=1024G, 16T=1024GX16

3. Two suction cups with rated lifting capacity of 16 tons

4. Stop valve j11 is a model, and dnxx represents diameter XX, w represents material, 16t represents nominal pressure 16

5. In the figure, t means circle, 1t and 16t means one circle and 16 circles respectively.

6.

16t: represents 1.6T, that is, the engine with 1.6L displacement is equipped with turbocharging device

20t: represents 2.0T, that is, the engine with 2.0L displacement is equipped with turbocharging device

T represents turbo charging, and its maximum power can be increased by 40% or even higher than that without turbocharger. This also means that the same engine after supercharging can output more power. Take our most common 1.8T turbocharged engine for example. After supercharging, its power can reach the level of 2.4L engine, but its fuel consumption is not much higher than that of 1.8L engine. On another level, it is to improve fuel economy and rece exhaust emissions

< H2 > extended information

points for attention in the use of turbocharged engine:

1. Do not use the turbine frequently. The frequent use here does not mean that we don't use it in daily life, but that the turbine is frequently involved in driving. Turbocharged vehicles have such a feature that when the speed is increased, the turbine will intervene. When the speed is limited to 120 km / h, for example, the turbine will stop if it is idling. If the turbine is involved again at this time, it will cause certain damage to the turbine. Therefore, do not overtake frequently on high speed or elevated road and let the turbine intervene, At the same time, try not to let the engine work at high speed for a long time, so that the turbine also works for a long time, which is not good for the engine and turbine

When it comes to carbon deposition, turbocharging should also pay attention to cleaning carbon deposition regularly. Generally speaking, clean the lubrication system about 10000 km; 20000-25000 clean the air intake system; 30000-35000 clean the fuel system, which will keep the turbocharged engine in an ideal state

7. According to the regulations of JB / T 308-2004 valve model compilation method:
z = = gate valve
4 = = connection mode: flange type
5 = structure form: Non rising stem type
W = sealing surface material: the same as valve body
16 = = pressure class: 1.6Mpa
t = = valve body material: copper

8. 06B, 9.525, 18 tooth sprocket, the maximum addenm circle diameter is 60.409 mm, the minimum addenm circle diameter is 57.181 mm, the preferred addenm circle diameter is 58.795 mm.