The graphics card of miner will not work

1.

Specific steps:

< UL >

first of all, we need to find a mine pool which is easy to operate and proces stable output. The role of the mine pool is to subdivide the data packets for each terminal. We can pay the corresponding amount of bitcoin according to the proportion of the data packets calculated by the terminal through the precise algorithm

3. The first way is to replace it with a new fan
the second method is: if the fan has a shaft core which can be oiled, it can be removed, the st on it can be cleaned thoroughly, and then a proper amount of engine oil can be dropped into the shaft core of the fan, so that the fan can operate normally after operation.

4. It is recommended to use 360 driver master software to install driver. It can intelligently detect hardware and match the most suitable driver for installation

5. Now all graphics cards support intelligent hovering technology, that is to say, when your graphics card temperature does not reach a certain level, the graphics card fan will not work and will not rotate, so as to rece noise and save power.

6. The graphics card didn't respond. There may be a problem with the graphics card itself, but it can't rule out the lack of power supply and the interface fault of the motherboard. In addition, it is easy to ignore the quality of the graphics card data line.

7. 1. In order to eliminate the trouble caused by the BIOS setting of this motherboard, first discharge the CMOS of BIOS. The instruction manual of discharge socket motherboard will indicate that if the discharge short-circuit plug cannot be found, remove the battery, and then short circuit the positive and negative shrapnel in the battery socket for one or two seconds with a screwdriver, and then put the battery back
2. Only connect the least equipment, such as CPU, CPU fan, single memory (in the new accessories, the memory is most likely to fail, of course, it is unlikely that two of them will fail together), power supply. Pay attention to the power supply, and don't forget to connect the special 12V power supply plug (eight wire, four yellow and four black) for CPU and display
after doing the above, you can try again to turn on the computer? If it can light up, it should be within two to five seconds. If it doesn't light up, try another memory and try again. If not, it's basically determined that it's a CPU or motherboard problem. Generally speaking, the probability of a problem with a newly purchased motherboard is greater than that of a CPU. Just go to the motherboard stall to communicate
of course, the most convenient way to determine whether there is a problem with the accessories on the computer is to remove it, such as installing the memory and power supply that you suspect to have a problem on another computer.

8. What will turn, pull out the graphics card to boot it. Maybe the video card doesn't work and the power supply is small.

9. Landlord, the graphics card itself will not turn. It must be the graphics fan that will turn. Just plug the graphics card into the PCI-E 2.0 x16 slot of the motherboard.

10. Generally, the video card fan is broken
or the power supply line of the video card fan is broken or the power supply part of the video card is broken
or the fan is stuck by the line
the CPU fan is rotating, and the power supply of the PCI slot is normal