Etpa one key mining

1. Aiminer is the original work of bitvf. The software supports single dig single dig eth, etc, HSR, Zec, BTG, FTC, XZC, ETF, MOAC, XmR, RVN, BTX, PGN, xdag, BTCP, BTF, lux, xvg. It supports double dig combination eth-dcr, eth-lbc, eth-pasc, eth-xvg, eth-sc, etc-dcr, etc-lbc, etc-pasc, etc-xvg, etc-sc, etc-dcr, etc-lbc, etc-pasc, etc-xvg, etc-sc. Aiminer optimizes the mining algorithm for the underlying GPU graphics card, counts the computing power of each coin, BIOS setting of a card, overclocking of GPU graphics card and other data of the hardware system, and makes an intelligent optimization mining setting
Aiminer provides mainstream ore pool and income query in various currencies by default, which is convenient for users to understand the income output ratio of mining in the first time. At present, Aiminer is the mining software with the most currency, the most complete mining kernel and the most conscientious pumping.

2. There are too many. Eth-dcr, eth-lbc, eth-pasc, eth-xvg, eth-sc, etc-dcr, etc-lbc, etc-pasc, etc-xvg, etp-sc, etp-dcr, etp-lbc, etp-pasc, etp-sc are all OK. There are other combinations. Choose for yourself. I've been using it for a while.

3.

Here's a simple technical table for your reference. There's liquid, gas and steam in it

for reference only, you'd better go to Fisher's professional software, which is accurate

4. Features: integrated structure, easy disassembly. High torque. Zero thrust load. Zhenrui electromechanical

5. Cu ETP has good conctivity, heat conction, corrosion resistance and processability, and can be used for welding and fiber welding. There are few impurities to rece the conctivity and thermal conctivity, and trace oxygen has little effect on the conctivity, thermal conctivity and processing properties, but it is easy to cause "hydrogen disease" and is not suitable for high temperature (such as & gt; three hundred and seventy ° Processing (annealing, welding, etc.) and use in recing atmosphere< Abstract
material name: Cu ETP
standard: (GB / t5231-2001)
chemical composition
1 Chemical Composition:
Cu + Ag: 99.90
Bi: 0.001
sb: 0.002
as: 0.002
Fe: 0.005
Pb: 0.005
s: 0.005
mechanical properties:
tensile strength: (RM / MPA) ≥ 295 Rockwell hardness: (HRF) ≥ 65
elongation: (%) ≥ 3 [3]

6.

Cw004a belongs to the European standard oxygen free copper, executive standard: en-13601-2002

cw004a has high conctivity, thermal conctivity, good corrosion resistance and processing performance, can be fusion welding and brazing. It is mainly used for conctive, thermal conctive and corrosion-resistant components, such as wires, cables, conctive screws, shells and various conits

The chemical composition of

cw004a is as follows:

cw004a-h035 is the state of the material, as shown in the figure below:

7. Cu-etp European standard en13599 electrical copper standard, r240 means supply status, tensile strength is not less than 240 MPa, corresponding to domestic brand T1

8. Generally, the baud rate is 9600, with no check bits and 8 data bits. In fact, the two communication terminals are OK all the time. Therefore, it depends on how the other party sets the baud rate

9. You don't write in Russian, even if it's spelled in English, it's not a word, it can't be translated