Gaoke mining
Publish: 2021-04-14 13:06:31
1. Router to plug in optical cat gigabit network port
2. 1. PC is connected to router LAN with network cable, which is set to obtain IP automatically
2. When the router is powered off, press and hold reset to power up (do not release reset)
3. Hold reset for about 5 seconds, and the router light will flash
4. PC network card obtains 192.168.1. X address (if not manually set)
5. Browser access http://192.168.1.1
if you brush the undead u-bootd
2. When the router is powered off, press and hold reset to power up (do not release reset)
3. Hold reset for about 5 seconds, and the router light will flash
4. PC network card obtains 192.168.1. X address (if not manually set)
5. Browser access http://192.168.1.1
if you brush the undead u-bootd
3. Yes, no problem. That's how it's all done
4. Yes,
Yes,
hope to adopt it,
thank you
Yes,
hope to adopt it,
thank you
5. It's not recommended that you do this. If it's easy to make bricks, the bricks will be wasted.
6. Construction procere of metal fluorocarbon paint
7. If you don't check auto acquire, fill in manually. IP and router LAN port are the same network segment, subnet mask is 255.255.255.0 by default, gateway is your router LAN port address, DNS is ISP
customer service 24 will answer for you.
customer service 24 will answer for you.
8. Mtk762076217628 routing can brush high Ke system! But Gao Ke did not update the firmware for two months. It is estimated that it will not be updated again! That's the free firmware! Aikuai firmware is OK, but firmware like MTK is not open to the public!
Hot content