Telecom mining machine
Publish: 2021-04-16 09:02:36
1. First of all, it is necessary to identify whether this is a money digging application, then understand its operation mode, and finally determine whether it can play.
2. Now ordinary broadband users dial-up Internet access mode, up and down network speed is inconsistent, up speed operators are limited. If the uplink rate is required, the fixed IP line optical broadband can be handled by the operator. There is no limit to the uplink rate of this broadband, and the uplink and downlink rates are the same. The price is higher.
3. Good. I like Digo very much
4. The first generation extraction process of ionic rare earth can be described as & quot; Extraction technology in different places;, Or it comes down to & quot; Pool leaching process & quot;. The main technological process is as follows: topsoil stripping → excavation of ore bearing body, ore transportation → leaching pool → taking electrolyte solution prepared according to a certain proportion (concentration requirement) as & quot; Eluent & quot; Or & quot; Leaching agent;, The solution is added to the leaching tank, and the concentration of & quot; Ionic phase & quot; Rare earth ore is analyzed by & quot; Percolation elution & quot; Or & quot; Leaching & quot; In the solution, the active ions exchange with rare earth ions; Ionic phase & quot; Rare earth is exchanged from the ore bearing carrier minerals and becomes a new state of rare earth; Add & quot; Top water;, The mother liquor containing rare earth was obtained; The mother liquor flows into the collecting tank or mother liquor tank through the pipeline or infusion ditch, and then enters the sedimentation tank; After leaching, the waste resie is removed from the leaching tank and discharged in different places → precipitant and impurity remover are added to the sedimentation tank to remove and precipitate the rare earth from the mother liquor and obtain mixed rare earth; After treatment, the supernatant was returned to the leaching tank for & quot; Eluent & quot; The purity of mixed rare earth oxide is more than 92%. It can be seen from the above that the key words in this process are: & quot; Topsoil stripping& quot; Excavation of ore bearing body& quot; Ore handling& quot; Leaching pool& quot; Eluent & quot& quot; Allopatric percolation elution& quot; Ion exchange& quot; Rare earth containing mother liquor& quot; Tailing discharge in different places& quot; Mother liquor pool& quot; Sedimentation tank& quot; Precipitant, impurity remover& quot; Precipitation and impurity removal& quot; Mixed rare earth& quot; Supernatant return& quot; Burn & quot& quot; REO ≥ 92% mixed rare earth oxides< br />
" Pool Leaching Technology & quot; Compared with the traditional proction process, the first, second and third processes are similar to those of the traditional mining process; The third, fourth and fifth working proceres are similar to those of traditional mineral processing and hydrometallurgy; The processes after the fifth process belong to the traditional hydrometallurgical processes. Among them, the & quot; Leaching pool;, It plays the role of connecting traditional mining and mineral processing professional operations, similar to the & quot; Raw ore & quot;; The & quot; Sedimentation tank;, However, it plays a role of connecting traditional mineral processing and hydrometallurgy, similar to the & quot; The raw material is & quot
therefore, similar to the main separation process of traditional mineral processing specialty, it is in & quot; Leaching pool & quot; And as an intermediate proct of the process, a mother liquor containing rare earth is obtained here; The typical hydrometallurgical process, which belongs to the traditional hydrometallurgical specialty, is mainly in & quot; Sedimentation tank & quot; And from this we get & quot; Rare earth concentrate & quot; The primary procts of China; Mixed rare earth & quot;; The & quot; Rare earth concentrate & quot; Final proct: mixed rare earth oxide with REO ≥ 92%
in addition, in the above operation process, we obtained & quot; Intermediate procts& quot; Primary procts & quot; And & quot; Final proct & quot;. That is, in & quot; Leaching pool & quot; The mother liquor containing rare earth was prepared by ion exchange; In & quot; Sedimentation tank & quot; The mixed rare earth was prepared by precipitation; In & quot; Burn & quot; The mixed rare earth oxide was prepared by the reaction of rare earth and rare earth. Therefore, in order to ensure the proct quality of ionic rare earth, we should control the technology in the three key operations
in this process, the & quot; Rare earth concentrate & quot; Proct is no longer the traditional concept of & quot; Rare earth concentrate & quot; Mineral procts, but relatively high purity & quot; Mixed rare earth oxides & quot; Procts. Strictly speaking, the final procts obtained from ion type rare earth mines are no longer subordinate to & quot; Mineral procts;, It is a proct in the field of hydrometallurgy. Obviously, the grade of its procts has been greatly improved compared with that of traditional mining procts
the above process structure is a new process in the development and utilization of rare earth mineral resources. It completely breaks the traditional process of rare earth resource development, and integrates a variety of specialties and processes to directly proce high purity mixed rare earth oxide procts in mines. Using this proction process, the quality index of the proct is difficult to achieve in the previous rare earth proction process. It can be seen that using this proct as raw material is very beneficial to the further processing of rare earth smelting
however, everything in the world often has & quot; Duality & quot;. Ionic rare earth has a very outstanding advantage, but because of its occurrence characteristics and process characteristics, it is not satisfactory on the other side. With & quot; Pool Leaching Technology & quot; After instrial proction, there are some very sharp and prominent problems: first, the ecological environment is greatly damaged. Due to the widespread occurrence of ionic rare earth in the shallow layer of the earth's surface, the distribution area is large; Pool Leaching Technology & quot; In fact, the proction process is a & quot; The movement of moving mountains;. According to statistics, for each ton of mixed rare earth oxide proction, about 1201-2001 tons of ore will be consumed. At the same time, 1200-2000 tons of tailings will be proced, and the sanding area is about 1 mu. Second, the utilization rate of resources is low and the waste of resources is large. In order to facilitate the mining and transportation of ore and the discharge of tailings, rece costs and save investment, the & quot; Leaching pool & quot; It is located in the middle and lower part of the hillside orebody; Leaching pool & quot; The following ore bodies are controlled by the established proction system; Ore pressing;, Especially if it is covered by tailings, it is more difficult to exploit. According to the data, the utilization rate of resources in the process table is generally less than 50%, and the lower is only about 25-30%.
" Pool Leaching Technology & quot; Compared with the traditional proction process, the first, second and third processes are similar to those of the traditional mining process; The third, fourth and fifth working proceres are similar to those of traditional mineral processing and hydrometallurgy; The processes after the fifth process belong to the traditional hydrometallurgical processes. Among them, the & quot; Leaching pool;, It plays the role of connecting traditional mining and mineral processing professional operations, similar to the & quot; Raw ore & quot;; The & quot; Sedimentation tank;, However, it plays a role of connecting traditional mineral processing and hydrometallurgy, similar to the & quot; The raw material is & quot
therefore, similar to the main separation process of traditional mineral processing specialty, it is in & quot; Leaching pool & quot; And as an intermediate proct of the process, a mother liquor containing rare earth is obtained here; The typical hydrometallurgical process, which belongs to the traditional hydrometallurgical specialty, is mainly in & quot; Sedimentation tank & quot; And from this we get & quot; Rare earth concentrate & quot; The primary procts of China; Mixed rare earth & quot;; The & quot; Rare earth concentrate & quot; Final proct: mixed rare earth oxide with REO ≥ 92%
in addition, in the above operation process, we obtained & quot; Intermediate procts& quot; Primary procts & quot; And & quot; Final proct & quot;. That is, in & quot; Leaching pool & quot; The mother liquor containing rare earth was prepared by ion exchange; In & quot; Sedimentation tank & quot; The mixed rare earth was prepared by precipitation; In & quot; Burn & quot; The mixed rare earth oxide was prepared by the reaction of rare earth and rare earth. Therefore, in order to ensure the proct quality of ionic rare earth, we should control the technology in the three key operations
in this process, the & quot; Rare earth concentrate & quot; Proct is no longer the traditional concept of & quot; Rare earth concentrate & quot; Mineral procts, but relatively high purity & quot; Mixed rare earth oxides & quot; Procts. Strictly speaking, the final procts obtained from ion type rare earth mines are no longer subordinate to & quot; Mineral procts;, It is a proct in the field of hydrometallurgy. Obviously, the grade of its procts has been greatly improved compared with that of traditional mining procts
the above process structure is a new process in the development and utilization of rare earth mineral resources. It completely breaks the traditional process of rare earth resource development, and integrates a variety of specialties and processes to directly proce high purity mixed rare earth oxide procts in mines. Using this proction process, the quality index of the proct is difficult to achieve in the previous rare earth proction process. It can be seen that using this proct as raw material is very beneficial to the further processing of rare earth smelting
however, everything in the world often has & quot; Duality & quot;. Ionic rare earth has a very outstanding advantage, but because of its occurrence characteristics and process characteristics, it is not satisfactory on the other side. With & quot; Pool Leaching Technology & quot; After instrial proction, there are some very sharp and prominent problems: first, the ecological environment is greatly damaged. Due to the widespread occurrence of ionic rare earth in the shallow layer of the earth's surface, the distribution area is large; Pool Leaching Technology & quot; In fact, the proction process is a & quot; The movement of moving mountains;. According to statistics, for each ton of mixed rare earth oxide proction, about 1201-2001 tons of ore will be consumed. At the same time, 1200-2000 tons of tailings will be proced, and the sanding area is about 1 mu. Second, the utilization rate of resources is low and the waste of resources is large. In order to facilitate the mining and transportation of ore and the discharge of tailings, rece costs and save investment, the & quot; Leaching pool & quot; It is located in the middle and lower part of the hillside orebody; Leaching pool & quot; The following ore bodies are controlled by the established proction system; Ore pressing;, Especially if it is covered by tailings, it is more difficult to exploit. According to the data, the utilization rate of resources in the process table is generally less than 50%, and the lower is only about 25-30%.
5. This kind of virtual currency has value only when it is used by people. It depends on the level of demand.
6. The phone card is used to make calls. It's not suitable to do other things
7. Buy the router or layer-3 router switch that supports multi dialing (ask the customer service whether it can realize this multi dialing function before buying) and then configure it to realize single broadband multi dialing
8. Mining words, generally and download speed has little to do with. Generally speaking, mining is directly related to the ascending speed. If the uplink speed is high, it will dig more
however, the uplink and downlink home use of operators are generally not equal. The bandwidth of 50m downlink is generally about 1m uplink. If you dig a mine, you can usually dig about one yuan a day.
however, the uplink and downlink home use of operators are generally not equal. The bandwidth of 50m downlink is generally about 1m uplink. If you dig a mine, you can usually dig about one yuan a day.
9. Shandong Branch, Guangdong Province
Hot content