How to change the drill bit after tomorrow
Publish: 2021-04-19 16:05:04
1. It's very difficult to get the official service. You need to get the props from the training. One nine innings is 500, two are 1000. I don't know if it will be added to the recipe machine!
2.
First, you need to enter the game and return to your manor
3. The first drill bit burst after two times
4. Isn't it possible for miners to use carbon
plain drills after tomorrow? It should be OK
plain drills after tomorrow? It should be OK
5.
1. Disconnect the power supply of the electric drill and pull out the plug of the power cord of the electric drill from the socket
6.
1. When you are ready to change the drill bit for the electric drill, first take out the electric drill and replace the drill bit installed. There is also an electric drill key for this kind of electric drill, as shown by the arrow 2 in the figure below
7. Clamp the place where the key is inserted with a vise, align the gear with a slant iron, and fix it with a hammer
8. This is a percussion drill. You need to push the front sleeve back before the drill can go in
9. < UL >
method 1: hold the small black ring of the drill bit in one hand, and grasp the big one on it with the other hand, and screw it in the opposite direction to clamp or loosen the drill bit. The black round button on the handle is for protection. The one inside is used to adjust the speed
Method 2: take down the drill bit: place the drill bit upside down on the ground (drill bit up), press the plastic ring at the root of the drill bit with the left hand down, hold the drill bit with the right hand and lift it up. When lifting, rotate the drill bit left and right to take it outHot content