How to mine Feixun K2P

1. K2P, K3 and the current k3c have all been tested. My family has an attic, and the router, K2P and K3 placed downstairs can detect the signal in the corner of the attic, but the k3c is the best signal at present. It seems that the 6dp antenna is still a good signal guarantee. If the pursuit of signal effect, it must be k3c is the best, especially when 2.4G and 5g are used at the same time, k3c is the best, K3 is not practical. In my environment, K2P needs to open 5g to have good practical effect, k3c is completely competent. It's worth recommending!

2. The volume is the same as K3, much lighter than K3, and the heat is not obvious; And the design is simple, there is no display, but there are more indicator lights. There is one at the WAN port, LAN port and the bottom. The indicator light at the bottom can judge the working state of the router according to the color; The power supply of 12v3a is much smaller than that of K3, which is more economical; The first Intel chip in China claims to be able to access 128 terminals; The signal is pretty good. The signal processing of the two machines is excellent

3. Connect the WiFi of the router with the mobile phone, input the management IP of the router in the address bar of the browser. The management IP of the router is the gateway IP of the terminal. Press enter to log in to the router management interface. Generally, the Internet access mode is set to obtain the IP dynamically, and then the wireless identification name, password and encryption type are set.

4.

The line setting method is as follows:

1. If the broadband is a telephone line access, prepare two shorter network cables. One network cable is used to connect the WAN interface between ADSL modem (CAT) and Fairchild router, and the other network cable is used to connect the computer and any one of the interfaces in Fairchild router lan1, lan2, lan3, lan4

3. Click Save and restart the router

5. The wireless router needs to be set according to the Internet environment to use
the setting method of wireless router is different in different Internet environment
if you need to dial a fiber-optic cat to connect to the wireless router, follow the following method:
1. Plug in the wireless router, do not connect the cat, and connect the computer to any LAN port of the wireless router
2. In the browser address bar, enter the IP address of the router (on the label on the back of the router), and enter the login user name and password to enter the settings page
3. Set according to PPPoE (ADSL virtual dial-up) mode, input internet account and password
4. Set SSID, encryption method and password
5. Save and restart
6. After setting, connect the cable from the cat LAN port to the WAN port of the wireless router.

6. Not bad, just the right size, four antenna layout, two independent 5dBi high gain antennas in each band, wider signal coverage. Compared with K1, the current indicator light is shrunk, but it is not a single color and has some changes. The operation is also simple. You can configure it when the mobile phone is connected. Of course, you can also configure it by connecting the computer with the network cable according to the old method. Very satisfied overall.

7.

Feixun K2P router into the router setting method, can be achieved through the following steps:

1, with a network cable connected to the router WAN port, the other end connected to the cat, computer network cable connected to the router LAN port any port

8. Strong signal, and no interference, speed can be fast

strong signal, does not mean no interference!!!!!

9. Log in to the router parameter settings page. There is an upgrade option in the system settings