How can chain mining be done by hand in my world

First of all, mining is usually done in the mine tunnel, and the efficiency of mining in the mine tunnel is also very high, because the minerals are exposed. But the size of the mine is limited, so we can wait until the mine is finished to develop the artificial mine. There are many ways to develop artificial mines, such as digging vertically down, or two grids straight ahead, which are all very common mining methods. However, these mining methods also have many loopholes. For example, when digging vertically down, if magma is encountered, it will die. This is a very fatal problem, although it can be avoided by digging straight ahead, But when you dig straight ahead, you will lose a lot of minerals and so on. The rule of mineral generation in my world is that the minerals generated will not be connected together, but scattered. Therefore, if straight-line mining is used, there will be ore leakage, while fishbone mining is scattered, so the efficiency is obviously higher than other mining methods

1. Open the folder and you will see the minecraft folder, as shown in the figure below

After entering the main interface, there are many options buttons at the bottom. Find "mods", click to open it, and then set parameters in it. The specific operation steps are as follows:

setting method:

1. Log in to my world main interface first

precautions:

1. The natural formation of round stone usually means that the player has g a ngeon, fortress or a place where magma and water mix

2. The natural generation of wood usually means that the player has g into the underground mine

3. The natural formation of moss stone usually means that players dig ngeons and fortresses

4. The natural generation of cracked stone brick usually means that the player has g the fortress