Yingtai main board Mining Co, Ltd

1. The driver of the graphics card has nothing to do with the motherboard. The d865pcd is not integrated with the graphics card
d865pcd integrates Realtek alc202 AC97 codec, also known as sound card
the sound card driver can use the following:
http://drivers.mydrivers.com/drivers/174-69625-Realtek-ALC100-ALC101-ALC200-ALC201-ALC201A-ALC202-ALC202A-ALC650-ALC655-ALC658

2.

The setting content is different, and the setting method is also different. Here, taking setting the U disk as the startup item as an example, the setting steps are introced:

1. insert the U disk, boot, press the "del" key to enter the BIOS setting when entering the first interface, and switch to the boot option with the "tab" key of the keyboard

   After

   

2. is set, restart the computer

3.

Download the BIOS file of the motherboard, decompress it and put it on the hard disk or U disk (FAT32)

press the power on key, immediately press the Del key, in the BIOS interface, press the F12 key to call up the BIOS refresh program< br />

4. It's very troublesome for beginners to insert the U disk and reset the first boot item to USB. Press F12 to select the USB boot BIOS refresh program and press y enter to refresh the BIOS.
it's not the DOS entered by CMD.
it's recommended for beginners to download afuwin4.33 and refresh the main board BIOS in the windows environment. Don't power off and clear the CMOS after refreshing

5. Download the BIOS file, format a partition of the hard disk into FAT32, unzip the BIOS file to FAT32 partition, boot the CD to DOS, and enter the BIOS file partition. Yingtai motherboard BIOS has automatic batch program. UP Just wait for it to finish. What's the problem? 545321371.

6.

1. Make U disk and start disk

2. Download the latest BIOS from the official website of the motherboard and unzip it to the root directory of the USB flash disk:

prompt "program ended normally" or when the cursor is not moving (pay attention to observe and wait), it indicates that the BIOS refresh is successful. Finally, restart to see if you can enter the operating system normally

7. It is necessary to brush the BIOS under pure DOS
which is very troublesome for beginners Insert the U disk and restart it
set the first boot item to USB
Press F12 to select USB to start the BIOS refresh program and press y to enter to refresh
DOS which is not entered by CMD
it is recommended for beginners to download
afuwin4.33
refresh the main board BIOS in the windows environment
the same
do not power off
clear the CMOS after refresh

8. Save the latest version of the BIOS file under the pipe network, restart the BIOS, and select the upgrade file

9. Preparation:
1. Download the main board BIOS firmware from the official website
2. Make the USB flash disk into a startup disk and put the downloaded firmware into the root directory of the USB flash disk
refresh BIOS:
1. In the boot interface, set the first boot item to U disk, save and restart again
2. If you are directly guided into DOS mode by the U disk, you can see the data in the U disk by pressing dir
3. At this time, you just need to enter "update" on the keyboard to refresh automatically. Update is a batch file, which combines a series of commands used for refreshing, so you don't need to remember a large number of DOS commands. The following is automatic completion
4. First, delete the old BIOS file automatically
5. Then write the new BIOS file automatically
6. After a few minutes, automatically jump out of the program and you will be successful.