Mining setting of z370 motherboard
Publish: 2021-04-28 17:22:34
1.
1. Method 1: use the start hotkey to quickly set. When you enter the first interface, immediately press the "del" key to enter the interface as shown in the figure below
2. To close CSM support is to use UEFI for quick start, and to use UEFI for quick start of mainboard requires operating system support
only the official versions of win8 and win10 of Microsoft support UEFI quick start. You may be using ghost version of the operating system
therefore, closing CSM support will cause the computer not to start normally
it is recommended to use UEFI to install the original Microsoft win10 operating system.
only the official versions of win8 and win10 of Microsoft support UEFI quick start. You may be using ghost version of the operating system
therefore, closing CSM support will cause the computer not to start normally
it is recommended to use UEFI to install the original Microsoft win10 operating system.
3. Enter the advanced options of BIOS and turn on the memory overclocking
it is not recommended to turn it on. If you understand overclocking, you can turn it on
by default, the frequency of 1600 is not full speed, but about 1300
it is not recommended to turn it on. If you understand overclocking, you can turn it on
by default, the frequency of 1600 is not full speed, but about 1300
4. Theoretically, yes, but the frequency of memory mole labeling is the upper limit of the most conservative test by the manufacturer. For example, the frequency of the standard parameter is 2400, which means that the maximum stable working frequency obtained by the manufacturer with the most stringent test means is 2400. If the frequency exceeds 2400, it may pass the test of daily software or games, but it is not the most stable state, Stability is the primary concern of computer hardware
therefore, it is recommended to buy memory moles with parameters of 3000 or higher. Spend money to buy stability, rather than later because of overclocking memory mole lead to all kinds of troubles, waste of time is equal to waste of money, waste of life.
therefore, it is recommended to buy memory moles with parameters of 3000 or higher. Spend money to buy stability, rather than later because of overclocking memory mole lead to all kinds of troubles, waste of time is equal to waste of money, waste of life.
5. It should be CPU frequency doubling, that is, the x37, and then the memory can also be OC (overclocking), but the power supply of this motherboard is not luxurious, so it is recommended to rece the overclocking
6. Budget, how much is the budget? It's meaningless to say that there is no budget
for example, ASUS z370a has two m.2 interfaces, which give you two
1t solid state drives. It supports al card SLI, and the upper two titans
v. The last two Titan
V need 1000W power supply, platinum power supply above 1000W
2000 +
not counting CPU, the total price is more than 5W.
for example, ASUS z370a has two m.2 interfaces, which give you two
1t solid state drives. It supports al card SLI, and the upper two titans
v. The last two Titan
V need 1000W power supply, platinum power supply above 1000W
2000 +
not counting CPU, the total price is more than 5W.
7. Gigabyte z370hd3 motherboard supports DDR4 2666mhz memory mole by default. Your memory mole's default frequency is 2400mhz. If it's not high frequency memory, it doesn't support overclocking.
8. Just click PCIe
and then move on
and then move on
9. Turn off "allow USB boot from PS2 / PS3 / PS4" in BIOS.
10. Enter the BIOS, power (power saving function setting), select AC back (system state selection when power is restored after power interruption) always on
Hot content