deeper怎麼挖礦
Ⅰ DeeperFishFinder怎麼樣好不好
Deeper FishFinder:幫你釣魚的手機配件
一種名為Deeper FishFinder的智能手機配件可能會讓你的垂釣之旅變得更加有趣。它是一個有聲納功能的防水球,可以掃描河水的深度,並把水下地形和魚類的位置信息直接發送到你的iOS或Android手機或平板電腦上。配套的應用則可以顯示魚的大致位置,以及一張河水深度圖,幫助你把誘餌投放在合適的區域。
漂浮的Deeper FishFinder可以探測120英尺(36.5米)的水深,藍牙覆蓋范圍達150英尺(45.7米)。你只要把這個配件綁到釣魚線上,然後拋到水中即可。此外,配套的應用不僅可以顯示防水球發揮的信息,還可以把捕獲的魚的照片發到Twitter和Facebook上。
Ⅱ 求翻譯 采礦專業不要用軟體翻譯的那種 加分題
proposed mathematical model and the developed
提出了數學模型和發展
program, a number of Chinese cases with varying
計劃,大量的中文例不同
coal seam inclinations are presented in this section.
介紹了煤層傾向這部分。
In these cases, the empirical values for the limit angles
在這些情況下,實證價值限制角度
(L and H) in different coal districts are used.
(L和H)地區在不同煤used.
Case 1: The typical final surface movements and
例1:典型的最終表面運動和
deformation profiles along a major transverse
沿著主要的橫向變形型材
cross-section in Fengfeng mining district is presented
峰峰礦區截面模型
in Fig. 5.
圖5。
The inclination of the coal seam is a
煤層的愛好是a
moderate 11° and the overburden depth on the lower
11°和適度的層深度低
panel edge is 750 ft (229 m).
面板邊750英尺(229米)。
The mining height and
采礦高度和
panel width are 5.5 ft (1.7 m) and 600 ft (183 m),
面板寬度5.5英尺(1.7米)和600英尺(183米)
respectively.
分別。
The lower (left) and upper (right) panel
較低的(左)和上(右)面板
edges are also shown in the figure.
邊緣也中顯示的圖表。
All three profiles
所有三個側面
show that this is a subcritical subsidence event.
表明,這是一個亞臨界沉降的事件。
The
這
maximum subsidence is 2.57 ft (0.78 m) located
最大沉降是2.57英尺(0.78米)的所在地
about 270 ft (82 m) from the left panel edge.
大約270英尺(82米)從左側面板的邊緣。
The
這
maximum horizontal displacements (H.D.) on both
最大水平位移(H.D.)兩者兼具
sides of the panel edges are about 1.1 ft (0.335 m).
該小組的兩側邊緣大約1.1英尺(0.335米)。
The maximum tensile strains on the lower and upper
的最大拉伸處於上下
sides of the panel are 6.37x10–3 and 7.02x10–3 ft/ft
該小組的兩側分別為6.37和7.02英尺/ x10-3 x10-3呎
(m/m), respectively.
(m / m),分別為。
The maximum compressive
最大壓
strain is 1.18x10–2 ft/ft (m/m) which is nearly double
x10-2應變是1.18英尺/英尺(m / m)的兩倍
of the maximum tensile strains.
的最大拉伸應變。
Case 2: Fig. 6 shows the predicted final surface
例2:圖6顯示預測最後的表面
and deformation profiles for a typical subsidence
一個典型和變形型材下陷
case in Jixi mining district.
雞西礦區案例。
In this case, the coal
在這種情況下,煤
seam dips at an angle of 18°.
角焊縫會時不時地18°。
The depth on the
深度的
deeper side is 400 ft (122 m).
更深的側面400英尺(122米)。
The mining height is
采礦的身高是
4.5 ft (1.37 m).
十4.5英尺(1.37米)。
The panel is again 600 ft.
委員會又600英尺。
Due to the
由於
relatively small depth; the resulting subsidence basin
相對較小的深度、產生的沉降盆地
is a supercritical one.
是一種超臨界之一。
However, the flat bottom portion
然而,平底分
of a supercritical subsidence basin is not necessarily
超臨界沉陷盆地的也不是必然的
flat but the maximum subsidence there decreases
但最高有平沉降減少
as the depth increases.
隨著深度增加。
The subsidence profile
開采沉陷剖面
on the deeper side is much gentler than that on
在更深的一邊比多溫和
the shallow side.
淺的一面。
Another observation is that the
另一個觀察,
maximum horizontal displacement, tensile and compressive
最大水平位移、拉伸和壓縮
strains on the deeper side are smaller that
處於更深的側小
those on the shallower side as expected.
那些在較淺的側與預期相符。
Case 3: The typical surface movement and deformation
案例3:典型的地表移動和變形性
profiles for Fuxin mining district are shownin Fig. 7.
阜新礦區型材是shownin圖7。
The input parameters for this case are: =
在這種場合下的輸入參數are:=
2°, h1 = 1050 ft (320 m), W = 600 ft (183 m) and m
2°,h1 = 1050英尺(320 m),W = 600英尺(183 m)和m
= 5.85 ft (1.78 m).
= 5.85英尺(1.78米)。
Due to much larger depth, the
由於更大的深度
degree of subcritical condition is even more than
亞臨界條件的程度甚至比
Case 1.
病例1。
Under the influences of larger depth and
影響下的深度和更大的
dipping angle, the center of the subsidence basin
浸漬角、沉降中心的盆地
shifted toward the deeper side from the center of the
轉向給球隊越深的中心
panel by a distance of about 103 ft (31 m).
板的長距約103英尺(31米)。
The peak
峰
tensile strain and horizontal displacement move beyond
拉應變水平位移和超越
the panel edge on the deeper side.
面板邊緣更深的一面。
It should
它應該
also be noted that two small steps (discontinuities)
也注意到的是,兩個小步驟(面)
were observed on the strain profile which is resulted
觀察應變簡介這是結果
from the discontinuity problem of the first derivative
從不連續問題的一階導數
of the adjusted influence function at its 「center』 in
調整功能的影響其「中心」
the current version.
當前的版本。
Ⅲ 安裝好deeper 系統重啟怎麼又進入Windows 系統
進入window系統,計算機屬性,高級選項,啟動和故障恢復,設置,選擇deeper為第一系統啟動
Ⅳ DEEPER,UAB怎麼樣
DEEPER,UAB,本省范圍內,當前企業的注冊資本屬於一般。
通過網路企業信用查看DEEPER,UAB更多信息和資訊。
Ⅳ 英語dig deeper into the vibrant怎麼翻譯
the +adj表示……的人,the vibrant就是充滿活力的人。整句話翻譯過來就是更加深入挖掘充滿活力的人。
Ⅵ deeper怎麼讀
/'di:pə/
Ⅶ 如何理解resnet中的deeper bottleneck architectures
去年的時候,微軟一幫子人搞了個152層的神經網路!WTF!詳情見論文!
論文太長了,今天只分析一下ResNet的核心內容之一,即「Deeper Bottleneck Architectures」(以下簡稱DBA),論文里的原圖是這樣的:
Deeper Bottleneck Architectures
說實話,畫的不怎麼樣,右邊的網路結構就是DBA啦!關於這張圖,論文的作者是這么說的
Because of concerns on the training time that we can afford, we modify the building block as a bottleneck design.
就是說,作者考慮到自己GPU的計算能力有限,所以才採用了bottleneck design!說到底還是沒錢上1080唄!不過2015年的時候1080還沒出來,那他為什麼不上TITAN,還是沒錢唄!
言歸正傳,換成bottleneck design以後,網路的參數減少了很多,訓練也就相對容易一些。然後我們再看一下原作中的ResNet全貌!
ResNet Architecture
來看50-layer那一欄,在進入到DBA層之前的網路比較簡單,分別是:①卷積層"7×7, 64, stride 2"、②BN層、③ReLU層、④池化層"3×3 max pool, stride 2",最終的輸出結果是一個大小為 [batch_size, height, width, kernels] 矩陣,很簡單,不再贅述,關於BN可以參考這里。
我們深入一下,再看第一個DBA內部,如下圖
Inside a DBA
很顯然,總共3×3=9層,可是原作畢竟篇幅有限,網路實現的細節不是很清楚,於是我就參考了Ryan Dahl的tensorflow-resnet程序源碼,按照Ryan Dahl實現的ResNet,畫出了DBA內部網路的具體實現,這個DBA是全網路中第一個DBA的前三層,輸入的image大小為[batch_size,56,56,64],輸出大小為[batch_size,56,56,256],如下圖
Ryan Dahl's DBA
圖已經說的很清楚啦!之後的網路就是N個上圖的結構疊加!我不太想做過多的說明了,一切盡在圖中!!
Ⅷ we need to go deeper怎麼裝備武器
E鍵裝備魚雷,游戲內有操作說明的